WaveWare Apollo T-2000 Informazioni Techniche Scaricare il pdf (Pagina 61)

Certification Manual

- 61 -

location of the zones should be simple but logical because it is determined

by the installer. For example, if two Concord Panels are installed, then it

makes sense to assemble the zone list according to area. The 100 and 300

halls may be on the West end, and the 200 and 400 halls may be on the

East end. If the panels are going to be installed to cover those respective

areas, than the zone list needs to reflect that. In other words, if there are 10

rooms each with a bed and bath station in every hall, then points 1-40 on

the West Concord will be the 100 and 300 halls. Points 1-40 on the East

Concord will be the 200 and 400 Halls.

Zone Planning

Second, the zones must be configured and numbered. Each control

panel can only handle 96 Zones (see section IV. Panels & Peripherals –

Concord Panels). This means that if there are more than 96 zones in the

facility that two or more panels will be required and only certain areas of the

facility will report to each panel. In addition, the installer must coordinate

with the facility’s staffing supervisor to determine which areas of the facility

will page to which pagers. Once this information has been determined

programming can begin.

Pager Planning

Ask the following questions:

1. How many CNA’s are working per hall per shift?

2. Who will receive the preliminary page, second escalation, third

escalation, fourth escalation?

3. Do staffing room assignments change at any time?

4. Are the names of the residents going to be paged?

Typically, it works well to set up the paging by hallway area. This

means that all of the pagers for a particular hall receive the same pages.

That way a staff person assigned to that hall can pick up any of the pagers

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 113 114

Nessun commento

WaveWare Apollo T-2000 Informazioni Techniche Pagina 61